Logo

P310D Engine Code Repair

Meaning of P310D engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P310D Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P310D code is occuring now you should check P310D repair processes.
Now don't ask yourself; What should you do with P310D code ?
The solution is here :

P310D Possible Solution:

P310D Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P310D Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

3
Ignition System Or Misfire

1
Ambient Air Temperature Sensor Circuit Low

0
Crankshaft Position Sensor A Circuit Malfunction

d

Regarding the P310D code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P310D OBD-II Diagnostic Powertrain (P) Trouble Code Description

P310D engine trouble code is about .

Main reason For P310D Code

The reason of P310D OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

P310D DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.